[Test-Equipment] Needed - approx 70K 4W pot

[hwhall at compuserve.com]

 Body diameter was about 1.5 inches but a bit larger could be accommodated. The standard quarter inch diameter shaft, 3/8 inch threaded mounting, shaft length approx 3/8 inch long (I can cut down a longer one if needed).

Wayne
WB4OGM



-----Original Message-----
From: call.jac <call.jac at hotmail.com>
To: hwhall <hwhall at compuserve.com>
Sent: Fri, Jul 5, 2013 11:02 pm
Subject: Re: [Test-Equipment] Needed - approx 70K 4W pot

  Hello: I have several available give me more info. ?Size shaft length etc.
?
JAC
?
T-Mobile. America's First Nationwide 4G Network.
  ?
?
?
------ Original Message ------
From: 
Date:?7/5/2013 10:19 PM
To:?boatanchors at mailman.qth.net;Test-Equipment at mailman.qth.net;Milsurplus at mailman.qth.net;
Subject:?[Test-Equipment] Needed - approx 70K 4W pot?
 ???Needed to repair an old R-C-L bridge.? 70k to 75k (maybe even a bit higher) would probably work fine, and 4 watts or better.? The original was a carbon composition pot but I image a wirewound might provide adequate control (this is used for the DC voltage across capacitors in test).    Thanks for the bandwidth & 73,    Wayne  WB4OGM  ??  ?  ______________________________________________________________ Test-Equipment mailing list Home: http://mailman.qth.net/mailman/listinfo/test-equipment Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Test-Equipment at mailman.qth.net  This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html