[Test-Equipment] Triplet 630 specs

[Scott Townley]

Richard,
My Triplett 630-NA manual says:
AC Volts-Frequency Response-20Hz to 20kHz for 1.5 thru 300V ranges, 
average responding calibrated to RMS of a pure sine wave.


On 4/7/2013 1:41 PM, Richard Knoppow wrote:
>     I used my Triplet 630 for an audio measurement today and realized 
> I had no idea what its frequency response was. The little instruction 
> book says only that its calibrated at 60 hz.  I put it across a 
> General Radio audio generator and found the response went up much 
> higher than I expected. The meter goes to 2 mhz and it was _rising_ at 
> that frequency. I did not fire up an RF signal generator but may do 
> that later.  At the low end it will follow the waveform well below 20 
> hz.  So, has anyone ever seen an actual spec for these things?
>
>
> -- 
> Richard Knoppow
> Los Angeles
> WB6KBL
> dickburk at ix.netcom.com
>


-- 
Scott Townley
http://www.nx7u.net