[Test-Equipment] stuff for sale ...

[Pete M]

1 -  HP N4691A eCal unit complete eCal option OOF ( 2 FM 3.5mm), 2 HP 
torque wrenches SMA and APC7. regular wrenches, cable, wood box. All 
complete and 100% HP. I can not test this unit on my VNA's because they 
are no new enough to have the FW to run them and no FW avail for PC, 
have been not able to find a cal interface for PC yet. So out it goes. 
Passes what limited tests I can do to it as per proper LEDs working etc. 
These sell for $4000 to $6000 on ePay. asking $875 + Shipping because I 
can not test it ( but is was bought as a working unit)

..  OR ...

Will sell cal unit and cable  w/o Wrenches and box for $625


2 - HP 478A Thermistor mount 100% working , Again will not ship unless 
verified by a 3rd party as validation of it working before shipping. $70 
+ Shipping.
..
3 - Weinshel Sliding attenuator, 2.5Ghz to 10Ghz, tested 100% working, 
model 953-10, .7 to 10 db, N-fm and N-m connectors $25 + shipping
..
4 - HP 8510B system, contains 85101B and 85102B (processor and IF unit), 
8514A 500Mhz to 18Ghz S-Parameter and an 8350B with an 83592B plug in. 
All pieces tested and working together With all inter connect cables and 
hpib cables. $3700 + can be picked up near Charlotte

----Will split apart and sell as individual pieces ----
..
5 - 10 ohm Calibration Standard Resistor Thompson + Levering Co. Tested 
good. $100 + Shipping
..
6 - HP 4275A LCR meter with 16047A test adapter. Working 100% 9 out of 
10 Physically, $800 + insured shipping ( as always certain trades could 
be considered ... if I need it for my test bench)
..
7 - HP 8712B VNA ( 300khz to 1300Mhz) has optional Ibasic, floppy disk, 
HPIB and Parallel port, Full VNA not a scalar NA, No burns on CRT and 
lots of life remaining, Unit is clean and Fully working with no issues. 
$1750 + Shipping
..
8 - HP 8672A Signal Generator, 2Ghz to 18.5Ghz, Working correctly, has 
attenuator option, no broken switches, internal High Precision osc and 
allows external 10Mhz in also, HPIB, unit 9+ out of 10. $975 + Shipping.
..
9 - HP8350B Sweeper mainframe, Working properly, v7.0 FW, 9+ out of 10, 
$195 + Shipping
..
10 - Noisecom NC346B Noise source,10Mhz to 18Ghz, BNC in SMA out, 28Vdc, 
22dbENR with proper cal table attached. Fully tested on my 8970B, 8971B, 
86712A system. It is better to use a higher ENR with an attenuator ... 
if something goes "opps" you burned out the attenuator not the NS. $640 
+ Shipped (CONUS Only) extra charge for outside US shipping.
..
11 - Megaphase cables, 24" SMA male to SMA Male, these are lab grade 
cables and factory tested to 4 Ghz and good to 18Ghz easily. $19 each + 
shipping.
..
12 - HP3585A Spectrum Analyzer 20Hz to 40Mhz, tested and working 
properly, Physical 9 out of 10, Electrical 10 out of 10, CRT bright and 
sharp with lots of life remaining, $750 Pick up only ...this weighs 6 
billion lbs ( over 90 anyway).
..
13 - HP8970B noise figure meter, tested and working 100%, 9.5 out of 10 
physical and 10 out of 10 electrical, $950 + Shipping ( and no that does 
not include a noise source )
..
14 - HP 4378A VOM, has internal Self cal feature, No leads included, 
this is from my lab and has been replaced with an 34401A, 100% working 
properly with no issues, 9.5+ out of 10, $135 + Shipping
..
15 - Eaton 2075-2a Noise figure meter 10Mhz to 1900Mhz, fully tested and 
working, complete with paper manual set (op, cal and Service) $750 + 
Shipping
..
16 - 8702B ( which is an 8753C + the additional optical feature FW also 
installed ),3Ghz top end, 85046A S-Parameter unit, All interconnect 
cables, New CRT module installed, Fully tested and working 100%, from my 
basement lab, $3300 + Shipping ( this is an exceptional unit )
..
..
Thanks for looking,
Pete WA2ODO

-- 
++++++CONFIDENTIALITY NOTICE++++++
The information in this email may be confidential and/or privileged. This email is intended to be reviewed by only the individual or organization named above. If you are not the intended recipient or an authorized representative of the intended recipient, you are herebynotified that any review, dissemination or copying of this email and its attachments, if any, or the information contained herein is prohibited. If you have received this email in error, please immediately notify the sender by return email and delete this email from your system.