[Test-Equipment] Source for Fluke 25/27 DMM parts? ADDENDUM

[Barry]

No, I don't think so.  The solvent/stripper only splattered a half-dozen or so droplets on the bezel - not enough to bond it all the way around.  The bezel fits into the housing very precisely and it appears to have been bonded at the factory that way.  I could be wrong, though, and there may be a trick to getting it out.  If so, I'm hoping someone knows how.

Thanks,
Barry - N4BUQ


 On Wed 09/05/12  9:46 AM , Bill Fuqua wlfuqu00 at uky.edu sent:
> Is it possible that the solvent dissolved and glued the plastic pieces 
> together?
> I can't see why they should be one piece.
> Bill
> 
> At 10:00 AM 5/5/2012 -0400, Barry wrote:
> >Yes.  Without a P/N, they coulddn't help.  I can
> find the Service Manual >for the Model 27 but not the 25.  I thought the
> housings were the same and >the 27 shows a separate piece for the bezel;
> however, when I disassembled >my Model 25, the bezel is a single piece of plastic
> that is somehow bonded >to the housing.  I think the only way to fix it is
> to replace the housing >and those are not easy to find  :(
> >
> >Thanks for the reply,
> >Barry - N4BUQ