[Test-Equipment] HP-3336B

[Fuqua, Bill L]

  These WECO connectors were mostly used in communication systems using frequency division multiplexing.
Such as older microwave line of site or troposcatter systems. The "Base Band" "Video",  not picture, would extend up 
to MHz and a good signal geneator and selective voltmeter on either end coiuld be used to check the system gain or loss.

73
bill wa4lav

 ________________________________________
From: test-equipment-bounces at mailman.qth.net [test-equipment-bounces at mailman.qth.net] On Behalf Of rbethman [rbethman at comcast.net]
Sent: Friday, December 30, 2011 4:00 PM
To: Test Equipment
Subject: [Test-Equipment] HP-3336B

Hello all,

I've got an HP-3336B on the way.

What are these WECO connectors on the front for output?

Can they be found?

I just want to use this as a "VFO" with 1V output to feed the crystal
jack on a BC-610 Tuning unit.

I'm going to take an old crystal, gut it, and drill a hole in the top.
I'll feed the 75 ohm output with a piece of RG-58.  The impedance
mismatch won't mean diddle.

The cable will only be about 3 to 5 feet in length.

Any ideas or connectors available?

Bob - N0DGN
______________________________________________________________
Test-Equipment mailing list
Home: http://mailman.qth.net/mailman/listinfo/test-equipment
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Test-Equipment at mailman.qth.net

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html