[Test-Equipment] Parting out TEK 465M USM-425

[Miles Anderson]

I recently did a "buy two klunkers build one good one" on a Tektronix Model
465M (USM-425) scope.

Here's what I've got left over:

(1)  Case components
        Mechanically good but scruffy looking upper case
        Mechanically good, scruffy-looking front cover -- inside compartment
door is shot
        Good handle
        Bottom of case is in rough shape, latches are shot

(2)    Vertical module
        Good, working module, one attenuator switch knob missing, the other
cracked, one "Uncal" knob & shaft missing

(3)    Horizontal module
        Good working module, switches need cleaning, "A Sweep" time/division
(outer) knob is cracked, counter dial on delay pot binds

(4)    Intermediate board (this is the bottom board with the power supply)
        PC board mechanically damaged but repaired; power supplies
completely functional and give nominal output voltages; there is some sort
of fault with the
                    intensity control and/or "Z axis"; all components are
present

(5)    CRT and mounting hardware (less plastic anti-implosion lens), all in
good shape, no burns

$5.00 plus actual shipping gets you any of the numbered component
assemblies. $20.00 plus actual shipping gets you the whole works. No
responses and the whole thing goes to the dump. Contact me off list
k2cby at optonline.net


Miles Anderson, K2CBY
16 Round Pond Ln
Sag Harbor, NY 11963