[Test-Equipment] Washing electronics
Charles Mumphrey
charlie at charlieselectronics.com
Sun Jan 1 22:11:18 EST 2006
I agree with your one way of cleaning, Sir....Just FYI...IMHO...I would
NOT recommend this cleaning procedure to be used by a "novice"
electronic technician unless there was some "learn'ed" supervision.
Unless, the "dirty" electronics is possibly a learning tool and could
easily be replaced, or, not of great value if "Kill-Roy" came a
knocking, Hi, Hi! But then again, could be a "Ham" thing. :-}
Charlie
Charles Mumphrey
Amateur Radio Station Kc5ozh
Kc5ozh Rowlett Repeater: 441.325 Mhz + 162.2
Kc5ozh Dallas Repeater: 441.950 Mhz + 162.2
Rowlett R.A.C.E.S. Unit 823
http://www.CharliesElectronics.com
> -------- Original Message --------
> Subject: [Test-Equipment] Washing electronics
> From: Rasputin Novgorod <priapulus at yahoo.com>
> Date: Sun, January 01, 2006 12:42 pm
> To: Test Equipment <Test-Equipment at mailman.qth.net>
>
> When working with dirty electronics, or cleanup
> after soldering, I'll clean by washing under the
> kitchen water tap and perhaps a little dish soap.
> (Soldering: start w/ flux remover).
>
> Scrubbing with a toothbrush or surgical hand brushes
> helps to free the dirt. Then I rinse thoroughly with
> tap water, then with distilled water, and finally
> with Alcohol to quicken the evaporation of water.
> Sometimes I'll finish with acetone (or to remove stubborn
> things), but there is a real danger that acetone will
> remove labels and markings!
>
> I use laboratory squirt bottles (about $5/ea from the
> local University chemistry store) which allow accurate
> squirting of liquids with a minimum of waste. The nozzle
> is fine enough and accurate enough to give something a
> quick spray at the bench, allowing the little bit of
> runoff drip onto the floor where it almost immediately
> evaporates w/o a mess. They even come with labels.
>
> I also use surgical hand brushes, which are small, disposable,
> very soft brushes used by doctors to cleanup before
> surgery. I get mine in Canada for about $1 at Lee Valley.
> Photo of jugs and brush here:
>
> http://www.ontariorocks.ca/temp/juggs.jpg
>
> Sincerely
> /b
>
More information about the Test-Equipment
mailing list