[Test-Equipment] Equipment handle needed

[Dr M J DiGirolamo]

Dear Colleagues,

    I am in need of a handle for an HP 8683B Signal Generator.  It is a 
universal handle that fits all the HP series of equipment of this same size.

    This is not one of handles which is die cast as part of the side of an 
instrument.  It is a handle which is meant to be removed in order to attach 
rack ears and can be easily spotted because it protrudes both forward and 
outward, away from the front instrument panel.

     The flange of the handle I need must mate into a recess which is 
approximately 1/2" by just a bit over 4 1/2"   I am in dire need of ONE but 
would gladly purchase up to 3 of them.  I also need the 2 bottom rear feet 
for this generator.  The are not the black feet but instead are the 
greenish ones with 3 prongs for attachment.

      All replies are appreciated, including suggestions of where I may 
purchase these items.

Best regards,

Mike DiGirolamo, W4XN
Charlottesville, VA 22901