[Test-Equipment] Hp 141T extenders....

[Geoff Greer]

Contact Bill Perry at William Perry Co (502-893-8724).  His prices are much better than Allied's.  I 
bought all the connectors I needed to make a full set or 141T extenders and the jumper cables for 
the 844X tracking generators etc.  

Geoff Greer


11/21/02 14:42:40, Dan Rae <rae4@ix.netcom.com> wrote:

>All the parts to make these can be had from various sources, with
>varying cost and degrees of difficulty.   The worst I found was the
>RF/IF cable to separate the two.  Each end cost $30 something plus from
>Allied, for the shell alone.  Coax inserts are cheapest from Mouser.
>
>Very well made commercial clones are available from George Kerber (sp?)
>who's address has disappeared into the black hole of one of my computer
>meltdowns....  Someone will know his url, I'm sure.
>
>Isn't google wonderful... www.glkinst.com/cables/hp_cables.htm has the
>details.
>
>Without these it is pretty well impossible to align the RF and IF units
>sompletely, many of the adjustments are on the inside of the RF/IF
>sandwich,
>
>Good luck
>Dan
>_______________________________________________
>Test-Equipment mailing list
>Test-Equipment@mailman.qth.net
>http://mailman.qth.net/mailman/listinfo/test-equipment
>