[Test-Equipment] RE: HP 5335A Counter Need Help!

Sat, 14 Dec 2002 23:13:39 -0800

You've removed the feet from the rear of the counter, right?  Most HP gear
of that era just had the two screws in the feet, plus one in the center rear
(possibly under a calibration sticker).  I'm not familiar with the plastic
strip you removed from the top -- nothing like that should be necessary?

-- jm

> -----Original Message-----
> From: [email protected]
> [mailto:[email protected]]On Behalf Of Mark J.
> Giubardo
> Sent: Saturday, December 14, 2002 11:04 PM
> To: [email protected]
> Subject: [Test-Equipment] RE: HP 5335A Counter Need Help!
>
>
> Hi, I am new to this list.
>
> I need to get the top and bottom covers off my HP 5335A counter. I have
> removed the plastic strip on the top and the three screws that
> appear to go
> through the cover, but still can't get it off. I don't want to
> damage it by
> too much force so I am asking for advice from someone that has experience
> with this instrument. I can slide off the side cover that does
> not have the
> handle (left side), but the side with the handle (after removing
> the handle)
> will only slide back about 1 inch and stops.
>
> Also need the HP part number for the Oven Oscillator Option 010.
>
> I have a manual coming via slow boat, but I need to get into the counter
> now.
>
> Thanks to anyone that can help,
>
> Mark   W1MJG
>
>
> _______________________________________________
> Test-Equipment mailing list
> [email protected]
> http://mailman.qth.net/mailman/listinfo/test-equipment
>