[TenTec] Ten-Tec 262G P.S.

[w4foa at comcast.net]

Tony, 
>From the "manual". 
Quote Output cables and connectors - The high current output should be drawn from the six pin Jones connector. Pins 3 and 4, the two vertical center pins are negative GND, and are marked on the chassis with a -sign. Pins 5 and 6, the two vertical pins nearest the end panel and marked +, are the positive terminals. Pins 1 and 2 are connected in series with the POWER switch and are used with a remote on-off switch, if desired. If the supply is to be turned on and off only by the front panel switch, pins 1 and 2 should be jumpered together in the plug. The unit will be inoperative without this jumper, or if the plug is removed from the socket.End quote. 
Hope this helps Tony. 
73 
Tony, W4FOA 


----- Original Message -----

From: "Tony Lelieveld" <va3dwi at gmail.com> 
To: "Tentec" <tentec at mailman.qth.net> 
Sent: Wednesday, November 18, 2015 9:48:59 PM 
Subject: [TenTec] Ten-Tec 262G P.S. 

Hi all, 
I am looking for a schematic for this power supply. A friend got one without a radio. It has the knobs on the front for a VOX system too but that is not important. We need to know which 2 pins need a jumper on the plug at the back so he can switch it on/off with the button on the front. Any info will be much appreciated. 
73, Tony VE3DWI. email (VA3DWI at gmail.com). 
______________________________________________________________ 
Tentec mailing list 
Home: http://mailman.qth.net/mailman/listinfo/tentec 
Help: http://mailman.qth.net/mmfaq.htm 
Post: mailto:Tentec at mailman.qth.net 

This list hosted by: http://www.qsl.net 
Please help support this email list: http://www.qsl.net/donate.html