[TenTec] Problem with Omni VI

[Ron]

On 4/6/2013 8:36 AM, Jaime Gomez wrote:
> I have an Omni VI Plus Model 564 that suddenly stopped receiving and
> transmitting eventhough the display shows the frequency and changes with
> the dial.
> Troubleshooting the unit I found that the 5.0 -5.5 MHz output (No. 85) from
> the 5.5 MHz PLL board does not change with the dial, it is locked in 5.8
> MHz and the voltage in pins 3 and 4 of the PLL IC (IC6 - MC145156P2) des
> not change with the dial as it is supposed to do, so the voltage
> controlling the VCO diodes V9 and V10 is fixed.
> My obvious suspect was IC6. I was lucky and found 2 from Hong Kong.
> Yesterday I received them and today I replaced IC6, but to my surprise the
> problem continues the same.
> It is almost impossible to send the equipment back to Ten Tec for repair
> from my country. Any hint as where should I continue looking at?
>
> Thank you, appreciate any help,
>
> 73, Jim, HK1N
> ______________________________________________________________
> Tentec mailing list
> Home: http://mailman.qth.net/mailman/listinfo/tentec
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Tentec at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
>
Here is the best price on an ESR, if you think you want to investigate 
the capacitors....

http://www.ebay.com/itm/MESR-100-AutoRanging-In-Circuit-ESR-Capacitor-Low-Ohm-Meter-Up-to-0-01-to-100R-/390427801773?pt=LH_DefaultDomain_0&hash=item5ae74f78ad