[TenTec] Pegasus tuner install help

[David McClafferty]

The green wire (serial control) goes to pin 3 of the
DB-9 connector on the DSP board. The red wire connects
to the large red wire (+13.8V) on the low pass filter
board. Hope this helps.

73, Dave,VE1ADH

 --- Rich McCabe <r.mccabe at 1967z28.com> wrote: 
> I am trying to reinstall a TenTec tuner in a Pegasus
> I just sold. I cant
> find my install instructions for the orginal TenTec
> peg tuner. I have a set
> for my later LDG memory tuner but not this one.
> 
> The RF circuit is pretty cut and dry but I dont
> remember where the red and
> green wires go. Can anyone give me some direction?
> 
> Thanks,
> 
> Rich
> kd0zv
> 
> 
> _______________________________________________
> Tentec mailing list
> Tentec at mailman.qth.net
> http://mailman.qth.net/mailman/listinfo/tentec
>  

______________________________________________________________________ 
Post your free ad now! http://personals.yahoo.ca