[TenTec] TT SCOUT

[David S.McCallum]

ok Jim thanks I just found my manual and there is some good words on
there, let me see if I can figure it out. I haven't run the scout for a
long time and really enjoyed using, have all the modules except 160 and
never had trouble getting out with it. Again thanks for the reply and 73
Mac

David S. McCallum/USAF RET./Chief Mac/W7sac/4
----- Original Message ----- 
From: "James C. Owen, III" <k4cgy_list at yahoo.com>
To: "Discussion of Tentec equipment" <tentec at mailman.qth.net>
Sent: Tuesday, August 03, 2004 11:33 AM
Subject: Re: [TenTec] TT SCOUT


Hi David,
   You WILL need some type of interface. I've forgotten if the
Scout uses a transistor or relay for amplifier control. Either
way it wouldn't be able to switch the SB-200 relay. The SB-200
uses a 120V AC relay, one side is switched to ground. You would
be wise to make up a remote box with a 12v DC relay for the Scout
to switch and be sure that the contacts will handle 120V AC at a
few hundred ma.
73 Jim K4CGY


--- "David S.McCallum" <w7sac2 at cox.net> wrote:

> I want to try running my SB-200 driving it with my TT SCOUT,
> any one know if I need AMP interface box/cable. All inputs
> appreciated, Mac
>
> David S. McCallum/USAF RET./Chief Mac/W7sac/4
> _______________________________________________
> Tentec mailing list
> Tentec at mailman.qth.net
> http://mailman.qth.net/mailman/listinfo/tentec
>





__________________________________
Do you Yahoo!?
New and Improved Yahoo! Mail - 100MB free storage!
http://promotions.yahoo.com/new_mail
_______________________________________________
Tentec mailing list
Tentec at mailman.qth.net
http://mailman.qth.net/mailman/listinfo/tentec