[Swan] 700cx 0utputs

[yash at aol.com]

Bob 
 at 70-100.00 apiece for 8950; thats the way Iam going to go.
thanks
dale wt4t



-----Original Message-----
From: Bob- W7LRD <w7lrd at comcast.net>
To: Discussion of equipment manufactured by Swan <swan at mailman.qth.net>
Sent: Wed, May 22, 2013 8:53 pm
Subject: Re: [Swan] 700cx 0utputs



A long time ago I used some 6LB6's to replace 8950's in 700cx. Worked just fine. 
Just series the filaments 
73 Bob W7LRD ----- Original Message -----
From: yash at aol.com 
To: swan at mailman.qth.net 
Sent: Wednesday, May 22, 2013 6:05:04 AM 
Subject: [Swan] 700cx 0utputs 

Working on my 700cx , found a bad 8950 output. Never realized how high prices 
have become on these tubes. I read of a change over to another tube ,just the 
same as the 8950 but has 6v filaments. Any one have any comment about the change 
over ,from what I have read ,its just a matter of some simple re wiring of the 
filaments pins. 
Also does anyone have a e mail address for john Bruchey,if he has one. Is there 
anyone else That could do a complete alignment on this 700cx. I no longer have a 
good enought bench to do the job. 
thanks 
dale wt4t 
______________________________________________________________ 
Swan mailing list 
Home: http://mailman.qth.net/mailman/listinfo/swan 
Help: http://mailman.qth.net/mmfaq.htm 
Post: mailto:Swan at mailman.qth.net 

This list hosted by: http://www.qsl.net 
Please help support this email list: http://www.qsl.net/donate.html 
______________________________________________________________
Swan mailing list
Home: http://mailman.qth.net/mailman/listinfo/swan
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Swan at mailman.qth.net

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html