[Swan] 700cx 0utputs

[yash at aol.com]

Mike 
 what would you want for the 8950's
dale wt4t



-----Original Message-----
From: Mike <ka7hbb at speedpal.com>
To: Discussion of equipment manufactured by Swan <swan at mailman.qth.net>
Sent: Wed, May 22, 2013 2:16 pm
Subject: Re: [Swan] 700cx 0utputs


On 5/22/2013 6:05 AM, yash at aol.com wrote:
>                       Working on my 700cx , found a bad  8950 output. Never 
realized how high prices have become on these tubes. I read of a change over to 
another tube ,just the same as the 8950 but has 6v filaments. Any one have any 
comment about the change over ,from what I have read ,its just a matter of some 
simple re wiring of the filaments pins.
>             Also does anyone have a e mail address for john Bruchey,if he has 
one.  Is there anyone else That could do a complete alignment on this 700cx. I 
no longer have a good enought bench to do the job.
> thanks
> dale wt4t
> ______________________________________________________________
> Swan mailing list
> Home: http://mailman.qth.net/mailman/listinfo/swan
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Swan at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
>
I might have a used 8950 or 2 laying around. Don't know what kind of 
shape they are in for sure.
Mike
______________________________________________________________
Swan mailing list
Home: http://mailman.qth.net/mailman/listinfo/swan
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Swan at mailman.qth.net

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html