[Swan] 700cx 0utputs

[yash at aol.com]

                     Working on my 700cx , found a bad  8950 output. Never realized how high prices have become on these tubes. I read of a change over to another tube ,just the same as the 8950 but has 6v filaments. Any one have any comment about the change over ,from what I have read ,its just a matter of some simple re wiring of the filaments pins. 
           Also does anyone have a e mail address for john Bruchey,if he has one.  Is there anyone else That could do a complete alignment on this 700cx. I no longer have a good enought bench to do the job. 
thanks
dale wt4t