[Swan] FS: Swan 350C and 117XC Power Supply

[Jim DiMauro]

Working 350 and power supply for sale in northern NJ.  I had this radio for about two years and put it on the air a few times with good results.  Since I've owned it I replaced the T/R relay and added a solid state calibrator, which is visible in the photos of the inside of the radio.  The calibrator was added as a no-holes mod, and operates from the front panel via the "Cal" position on the function switch.  The calibrator is powered by a 9-Volt battery that clips into a holder on the rear panel.  I re-capped and replaced all of the rectifier diodes in the power supply and it works well.  OK, now on to the fine print.

The radio is clean inside, but has scratches and scuffs on the outside of the cabinet.  The front panel is in good shape except for a couple of scratches near the meter.  The power supply cabinet is ratty inside and out.  A few months ago the shelf that supported the radio and power supply gave way while I was working on it, and I could catch only one of the pieces.  I caught the radio, but the PS crashed to the ground, denting and deforming the cabinet.  The Jones plug on the rear of the PS no longer sits true, but tilts downward some as you'll see in the photos.  It works fine.

Photos here: www.dcaconsulting.org/photos/350C.

Make me an offer.  You pick up in Vernon, NJ or Harrisburg, PA, or pay to pack and ship.

73,
Jim
W2BVM