[SMCARA] How do I...

[Sam Leach]

Same clamp Tom used and a bumper jack.  I might have one, if I can find it.

I like Tom's hose trick, but you still may need the jack.

Call me, if I need to dig one out.

73

Sam
301-994-9732

-----Original Message-----
From: smcara-bounces at mailman.qth.net [mailto:smcara-bounces at mailman.qth.net]
On Behalf Of Clarke, Tom AIR4.0P NATOPS
Sent: Monday, May 10, 2010 12:27 PM
To: Tom Shelton
Cc: SMCARA at mailman.qth.net
Subject: Re: [SMCARA] How do I...

Hi Tom,

Another thing to try that has worked for me in the past, both putting them
in and getting them out, is hydraulics.  Take your garden hose and put it
over the top of the rod and start the flow.  After a few minutes, it should
loosen up enough to gorilla it out. Try the clamp method with a 2x4 to lever
it up.

If that doesn't work, Pete's brute force method is probably sure-fire!  I
have seen fence contractors use that Amica device to install chain link
fence posts.  Works like a champ down in sandy Florida, but might be a
little tougher up here in our clay.

FYI, the NEC says that anything less than an 8 foot ground rod is
ineffective and not IAW code.

73 de Tom/W4OKW


Tom Clarke
Wyle, Inc  Aeronautics
P3 Product Lead, PEO(A)
USN/USMC National Airworthiness Office
Naval Air Systems Command, AIR-4.0P
(301) 995-3793/DSN 995-3793
Fax: (301) 342-3776
Cell (301) 904-2053
frederic.clarke at navy.mil

"Do not let spacious plans for a new world divert your energies from saving
what is left of the old."

Winston Churchill


-----Original Message-----
From: smcara-bounces at mailman.qth.net [mailto:smcara-bounces at mailman.qth.net]
On Behalf Of Butt, Peter CIV NAVAIRSYSCOM 5.4.1
Sent: Monday, May 10, 2010 10:54 AM
To: Tom Shelton
Cc: SMCARA at mailman.qth.net
Subject: Re: [SMCARA] How do I...

 
Tom,

  There are a wealth of ways to get these out of the ground...

  The easiest way is one that I've used a few times.  Install a standard
ground clamp near the top, borrow any hydraulic-assisted device (backhoe,
small tractor with a three-point hitch, bucket loader, etc. and tie the two
together.  Up it comes... but there usually is some costs associated with
this solution (unless you have a friend who owns one of these devices who
likes beer).

  Another way is to 'leverage' the power of mechanical advantage.  See the
picture at this site (http://www.amicatech.com/amicaroddriver.html) to see
what I'm talking about.  Basically, using the ground clamp I mentioned
above, tie to a long steel pole (5-6' or longer) with attach point about 1'
from end.  Use the longer portion to pull up.  You may have to grunt a
little depending on how long (or short) the longer portion of the pole is.

  Let me know if it works.

  Vr, Pete (WA3UMY)




-----Original Message-----
From: smcara-bounces at mailman.qth.net [mailto:smcara-bounces at mailman.qth.net]
On Behalf Of Tom Shelton
Sent: Monday, May 10, 2010 10:32
To: SMCARA Reflector (E-mail)
Subject: [SMCARA] How do I...

I have two 6-foot long copper ground rods in the ground and I have since
moved my antenna and need to get them up and out of the earth.  Only about
4&1/2 feet are in the ground and I've tried everything.  I hit them with a
sledge hammer to loosen them up.  I can spin them around with a pipe wrench.
But as far as pulling them up, they won't budge.  Any ideas or special tools
I need.  Tammy already said that driving them all the way into the ground is
not a viable option - they've got to come up...

Tom Shelton 

No electrons were harmed in the sending of this message, although several
were terribly inconvenienced.
Draco Dormiens Nunquam Titillandus
______________________________________________________________
SMCARA mailing list
Home: http://mailman.qth.net/mailman/listinfo/smcara
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:SMCARA at mailman.qth.net

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html