[SkyHub] Tait tm8105, asl3, pi3, urixb, standalone repeater controller

[Part 15 Engineer]

Hi,

I'm looking to make a standalone (non linked) gmrs repeater out of a pi3b,
asl3 and a couple of uhf tait mobiles.

I need a step by step idiots guide to setting up the pi3 with asl3 as a
standalone repeater controller.

I'm not a linux guru but can follow step by step instructions.

I need, cw or voice id, tot, and if capable remote enable / disable of
repeater.

The ctcss is done in the taits although I can change that to the asl3 if
that is better.

I have the pi flashed with asl3 already.

Also need a wiring chart for tait tm8105 to the urixb.

This is a repeater so it's a two radio arrangement.

I figured my way through putty and windows cmd shell for accessing the asl
menu and I competent with navigating the command line stuff.

I just need to know what to change and where to change it.

Thanks

Robert P Chrysafis
Wrcm325
Kc8gpd
Scottsbluff NE
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://mailman.qth.net/pipermail/skyhub/attachments/20260919/d5695242/attachment.html>