[SignalOne] Who works on CX7s?
David Bertman
[email protected]
Wed, 16 Jan 2002 09:00:31 -0800
Hi Charlie ---
Boy, I wish I could take you up on your offer. Maybe down the road
abit
I could do this sort of thing. Right now my job is too demanding and I am
on the
road most of the time. I have a cx7B of my own waiting for work, among a
few other
projects.
Paul Kluwe might be willing to do this work -- I know that he is
shifting over
to a different focus. I would love to help you, but just cannot do it now.
I am almost
positive the problem is a bad regulator. But it would be suicidal for me
to add anything
to my schedule right now.
Dave
"Charles Hugg"
<[email protected] To: <[email protected]>
et> cc:
Sent by: Subject: Re: [SignalOne] Who works on CX7s?
signalone-admin@mailm
an.qth.net
01/15/2002 06:35 PM
Please respond to
signalone
Dave,
Why don't I just box this thing up and ship it to you. You could fix this
problem and maybe check it out all around. I don't think that it needs
much,
but I don't have any equipment and very little skills.
I would be willing to pay a reasonable, well a little more than reasonable,
price to get this rig up and running.
It deserves to be back on the air.
Just a thought. I am not in a big hurry, so you could work it into your
schedule. Also, I know how pack so that it would arrive safely.
Thanks for considering,
Charlie
----- Original Message -----
From: David Bertman <[email protected]>
To: <[email protected]>
Sent: Tuesday, January 15, 2002 7:21 AM
Subject: Re: [SignalOne] Who works on CX7s?
>
> Hi --
>
> Well, I'm not guaranteeing anything, but it sure sounds like this is
> the problem.
> It is not too hard to change, but requires some patience.
>
> First, to diagnose the problem you need to check the 34v power
supply.
> This
> should be pin 132 or 131 of your power supply (I have only worked on old
> ps, but from
> schematic this is same on "B" ps). If regulator is out the level will be
> over 40v (normally
> about 37v with no load). If this is the problem, the 34 v regulation is
> out and you need
> to replace the pass transistor q4 mounted on rear of chassis. The other
> transistors which
> determine its bias could be gone too -- these are all on the ps board.
> All can be
> replaced without pulling pins on ps board (and I have replaced all!).
The
> problem could
> also be in other regulators. On "B" ps these are three terminal devices,
> and are also
> mounted on chassis rear.
>
> Best way to check for hum from this type of source is with a scope.
> You will
> see quite a dramatice angular form when regulation is out.
>
> Hope this helps.
>
> Dave AB7B
>
>
>
>
> _______________________________________________
> SignalOne mailing list
> [email protected]
> http://mailman.qth.net/mailman/listinfo/signalone
_______________________________________________
SignalOne mailing list
[email protected]
http://mailman.qth.net/mailman/listinfo/signalone