AW: [Signalone] Signal/One Service and Repairs

[Graf Ulrich Ulm]

Hi Paul,

since this repair work is part of your hobby and no business, you might be
willing to give me some advice. About two years ago I got a Milspec 1030
with some severe problems which I could all solve. The radio works very
satisfactorily now, particularly after the integration of a relay switched
highpass filter box to avoid the strong 2nd order intermod distortion caused
by the large BC signal density here in Europe.

Just by chance I wanted to try vox operation I normally don't use and found
the modulation level to be less than half of the average level needed to
feed the rig correctly. I could't even get sufficient output in vox mode. My
first investigation did not show any impact of the PTT/VOX switch control
onto the mic level. Do you eventually have an idea?

Merry Christmas, good start into 2002 and best 73

Uli, DK4SX

-----Urspr�ngliche Nachricht-----
Von: PKluwe@aol.com [mailto:PKluwe@aol.com]
Gesendet am: Freitag, 21. Dezember 2001 06:05
An: signalone@mailman.qth.net
Betreff: [Signalone] Signal/One Service and Repairs

I get asked about this quite often, so thought i'd post to the signal/one 
list.

I am currently active doing service and repair work on the Signal/One models

CX11, CX11A, MilSpec 1030, MilSpec 1030C, and the MilSpec 1030CI.  I used to

work with Paul Kollar and Harry Snyder on these, and as they have both
become 
silent keys, i am pleased to be able to continue their work.  This is just a

diversion of the ham radio hobby on my part and *not* a business venture.

My contact information is:

Paul Kluwe,  W8ZO
PO Box 84
Manchester, MI 48158-0084

Home Phone 734.428.2000
Home FAX:  734.428.1000

Thanks & 73,
-Paul  W8ZO
.
.
.
_______________________________________________
Signalone mailing list
Signalone@mailman.qth.net
http://mailman.qth.net/mailman/listinfo/signalone