[SIERA] FS

[vhfplus at bmg50.com]

I have the following for sale:

1) Yaesu FT-1802M 50-watt 2-meter FM rig. Like new with original carton
and accessories. Details at:

http://www.universal-radio.com/catalog/fm_txvrs/1802spec.html

2) Uniden Bearcat BC-350C scanner. Like new with original carton and
accessories. Details at:

http://www.universal-radio.com/CATALOG/scanners/3417spec.html

3) Diawa CN-101L cross-needle SWR/Power meter. 1.8 to 150MHz. Good
condition. $60.00.

4) Tektronix 7704A 'scope mainframe with 7A26 Dual-trace amp, 7B53A
Dual-trace timebase and original Tektronix Operating and Service manuals
for the mainframe. The 'scope works but does not have full vertical sweep.
The CRT appears to be in fine condition and the plug-ins both seem to work
as they should. Physically the 'scope is in very good condition. $50.00
for all.

5) Tektronix 567 Readout Oscilloscope, as is, $20.00.

6) Hewlett-Packard 202A Low Frequency (.01 to 1200 Hz) Function Generator
(sine, square and triangular waveforms). Old, large,  tube-type unit but
it works and the output waveforms looked good last time I had it hooked to
a 'scope. $20.00.

7) Sunaire PS-1900A HV power supply designed for running a 4CX1500A at 1kw
continuous commercial service. $300.00. Details at:

http://www.surplussales.com/powersupplies/PowerS-2.html

The supply has some external scrapes and scratches but is in excellent
condition internally. I do not have the interface cables so I cannot test
the unit but the fellow from whom I bought it indicates that it was tested
with the matching Sunaire PA and works fine. If you were to buy a
comparable Peter Dahl, or comparable, plate transformer it would cost you
at least what I am asking for the whole supply.

8) HV power supply capacitor. Sprague A24-5, 8uf at 3kv peak and 2kv
working voltage. Original part from a Heath HA-10 amp. I had the filtrer
choke in the HA-10 short so replaced the choke/capacitor with a capacitor
input. This cap comes with the original mounting brackets. $10.00.

9) Total of 6 10-foot Tri-Ex T-15 tower straight sections. Constructed
like, but slightly larger than, Rohn 25. Two sections have anti-torque guy
brackets attached. Guying at two levels is adequate at 70mph wind velocity
according to the manufacturer's web site. This tower is now handled by
Tashjian Towers in Sanger, CA. Information at:

http://www.tashtowers.com/guytowers.html

Tashjian does have at least rotor plates available. I have never inquired
about other accessories. $200.00 for all 6 sections. I am retaining 6
sections for my own use.

Local pickup, in Silver Springs, necessary on the large items. I will ship
the smaller items if needed but will add that cost to the total price.
Payment by PayPal okay if you have an account.

If interested, e-mail or call 775-577-4621 after 6pm any evening.

Thanks,

Jack, W6NF