[SFDXA] New ANAN-8000DLE HF & 6M 200W SDR Transceiver - From QRZnow

[Bill]

ANAN-8000DLE HF & 6M 200W SDR Transceiver
Posted date: November 23, 2016in: EquipmentNo Comments
Twitter

The ANAN-8000DLE HF & 6M 200W SDR Transceiver meets and exceeds the 
requirements of even the most discerning Amateur Radio Operator, it is 
based on the work of the OpenHPSDR community.

Keeping in mind the various requirements posed by new cutting edge 
technologies implemented in the radio it has been designed from scratch, 
the design successes of the previous generation hardware has been 
improved in the new implementation.

The ANAN-8000DLE uses an entirely new redesigned transmit chain keeping 
in mind PureSignal (Predistortion), the result is astounding IMD 
performance, the typical transmit IMD distortion is about a 1000 times 
lower than that achieved by a typical modern transceiver available 
today. It is the world’s first Amateur Radio transceiver to use a 50v 
LDMOS device in the finals.

The ANAN-8000DLE includes two phase synchronous front ends to enable 
Diversity reception,

An internal four phase low noise boost supply is used to convert 13.8v 
to 50v for the finals, this enables the user to have the flexibility of 
using industry standard 13.8v DC as well as battery power whilst at the 
same time the radio provides all the advantages of the 50v LDMOS amplifier.

The front panel Display is microprocessor driven and displays all 
critical parameters such as Forward and Reflected Power, SWR, Current, 
Voltage, Temperature. The microprocessor also provides real time 
protection for all these parameters.

Preorder special pricing for a limited time only, expected ship date 
early first quarter 2017.

US Customers please place your Orders with HRO and Gigaparts, both 
Distributors will honour this price.

General Specifications:

     Architecture: Direct Sampling DDC/DUC Transceiver
     Interface: Ethernet
     Phase Noise (Clock): -149dB @ 10Khz
     TCXO Stability (Typical): /- .1 PPM
     Modes: CW, SSB, NFM, AM, Digital
     Antenna Ports: Three SO-239 50 ohms Software Configurable Ports, 
One BNC for RX2
     Frequency Resolution: 1 Hz

Electrical Specifications:

     13.8v DC @ 35A, 3A Receive/35A Transmit

Mechanical Specifications:

     12Kg (approx. Weight)
     Dimensions: 483MM (L)  x 123MM (H) x  320MM (D) (Not including 
extrusions)
     Stainless Steel Chassis and Aluminum Heatsink

Receiver Specifications:

     Receiver Architecture: Direct Down Conversion
     Dual 16 bit Phase Synchronous ADCs
     Independent filter banks for each ADC
     10/6M LNAs
     Frequency Coverage: 9Khz to 60Mhz
     Attenuator: 1-30dB step attenuator
     Reciprocal Mixing Dynamic Range (RMDR): 116dB @ 2Khz
     Receiver Phase noise: -149dB @ 10Khz
     Image rejection: 100dB
     Hardware support for 7 independent receivers assignable to either ADC

Transmitter Specifications:

     Transmitter Architecture: Direct Up Conversion
     DAC Resolution: 16 bit
     RF Output Power: 1-200W SSB, CW, FM, RTTY, Digital; 1-50W AM
     IMD: IMD3 typically -72dB @ 200W output on 20M
     Harmonics: Typically better than -50dBc on HF and -60dBc on 6M
     Carrier and Opposite Sideband Suppression: Better than -80dBc
     Transverter IF Output: 0db to 15dB

IOs:

     RCA Line In, Line Out, PTT in, PTT Out
     DB9 Seven Software configurable Open Collector Outputs
     BNC XVTR TX Out, 10Mhz Reference Input
     6.25mm Barrel Mic, CW Key, Headphones and Speaker Outputs
     SMA PureSignal (Predistortion) Loop Input and Output
     RJ45 Ethernet LAN Connector
     $3995.00

Article With Pictures:
http://qrznow.com/category/equipment/