[South Florida DX Association] DX Engineering, ICE, and PolyPhaser Antenna Products

Michael M. Raskin rask1553 at bellsouth.net
Fri Jul 3 14:40:33 EDT 2009


Here are some goodies for antenna projects that never made it off the 
drawing board.  Most are brand new, unopened, and still in the original box. 
Pick up in Stuart or Tamarac and no shipping charges.

DXE-FVI-1 - Feedline Voltage Injector - is a receive-only Feedline Voltage 
Injector which allows you to place dc voltage on a coaxial cable 
transmission line for powering active accessory devices. Two FVIs may be 
connected back to back to allow you to insert a dc voltage on the 
transmission line and remove it at the other end - keeping the input and 
output RF devices isolated from the voltage.  Included 120 VAC 60 Hz to 12 
Vdc wall mounted transformer DC power supply. Brand new in the box.  $25 (2 
available)

DXE-FCC050-H05-A - Feedline Current Choke for 50 Ohm coax-fed antennas 
(input and output connectors are SO-239) - Aluminum Enclosure - Prevents 
unwanted RFI by eliminating feedline current and radiation. It provides 
excellent feedline decoupling from 1 to 60 MHz and is power rated for 2 kW 
continuous, 5 kW intermittent. Brand new in the box.  $50

DXE-FCC050-H05-P - SAME AS ABOVE, but used and in plastic (not aluminum) 
case.  $30.

DXE-VFCC-H05-A - 2/5 kW Vertical Feedline Current Choke for HF coax-fed 
Vertical Antennas.  Adding a Feedline Current Choke at the base of a 
vertical antenna will substantially reduce unwanted feedline radiation. 
Rated for 2 kW continuous, 5 kW intermittent power. Includes insulated 
mounting plate and hardware for mounting the VFCC at the base of a vertical 
or to a ground-mounted pipe, and two tinned copper braid straps to connect 
between the vertical, VFCC and a radial plate or system.  Brand new, in the 
box. $70

DXE-UE-1P   Utility Enclosure Package - Included with the DXE-UE-1P: 
Weather-tight 12-1/4 in. x 12 in. x 5-1/4 in.  enclosure,  plated #8 x 1-1/2 
Wood Screws (3), four plastic mounting plate spacers, 8 in. x 9.5 in. 
6061-T6 aluminum mounting plate with stainless mounting screws, and four 
weather-tight coax feed through couplers.  Never used although I have 
drilled out a slot at the bottom for 2" wide copper grounding strap.  $20

DXE-CFT-1P - Extra coax feed-thru, 6-pack - Brand new, still in unopened 
plastic bag. $10

DXE-83-798-KIT - Chassis mount genuine Amphenol SO-239 with Teflon 
insulation for high power situations.  Packaged with the correct stainless 
bolts, flat washers, star washers and Nylok locking nuts.  Brand new, still 
in sealed plastic bag.  $5

DXE-363-SST Bulkhead Fitting, SO-239 Socket, Silver Plating, Teflon 
Insulation - It comes with two nuts to secure the connector to radial plate 
or other flat surface. Silver plated, Teflon insulated, very low loss, high 
electrical break down, 2 in. long.  Brand new, still in sealed plastic bag. 
$4

PolyPhaser PPC-IS-RCT Lightning Protector, Rotor Control, DC Shunt, 8 Lines, 
60VAC Lightning protector for 8 line rotor controllers and is used to 
protect controllers. Brand new in the box.  $75

PolyPhaser IS-B50LU-C0 Lightning Protector - UHF Female Connectors, Bulkhead 
Mount, 2 kW at HF, 1.5-400MHz.  Used, but only indoors, and looks brand new. 
$40 (5 available).

I.C.E. Model 477 AC Line Filter - 240VAC, 25A, 6000W max.  Uses pair of 30A 
AGC fuses.  Has three 20A 240VAC receptacles and 6' cord.  In 3" x 3" x 
1-1/2" aluminum enclosure.  In very good condition.  $50

Check this stuff out at www.dxengineering.com and www.iceradioproducts.com

Mike, W4UM 



More information about the SFDXA mailing list