[South Florida DX Association] Antenna Stuff
Michael Raskin
rask1553 at bellsouth.net
Mon Jan 16 15:47:09 EST 2006
More antenna stuff for sale
1) DX Engineering Stainless Steel Radial Plate. DXE-RADP-1P. The DX
Engineering Radial Plate is meant for those of you that have or are building
a quarter wave vertical antenna and who want an easy, neat and effective way
to connect those essential radial wires and the coax to your vertical
antenna for the lowest takeoff angle and strongest signals. Brand new, in
the box, with 20 stainless steel bolt sets. $35.
2) DX Engineering DXE-83-798-KIT. Chassis mount genuine amphenol SO-239
with Teflon insulation for high power situations.
Packaged with the correct stainless bolts, flatwashers, star washers and
Nylok locking nuts. Brand new, in sealed plastic bag. Can be mounted on
radial plate. $5
3) DX Engineering DXE-8X16-RT Pigtail. 16" long pigtail. This cable
makes connecting the Hustler BTV antennas to 50 Ohm coax easy! Brand new.
$10
4) DX Engineering DXE-363-SST. Bulkhead Fitting, SO-239 Socket, Silver
Plating, Teflon Insulation. This superior bulkhead connector uses silver
plated outer and inner conductors and a Teflon insulator. The connector has
very low loss and high electrical break down. Brand new is sealed plastic
bag. $5
5) Lance Johnson Engineering GP-1 Radial Ground Plate. Rugged 1/4" thick
construction, 10" diameter - fits inside Rohn 25-G sections, two dozen (24)
radial tie points, convenient hole for PL-259 connector, flange mount
accepts 2" diameter mast (perfect for elevated radials), and locking
fasteners (3) on flange. The GP-1 is suitable for both Ground and Elevated
Vertical Installations. The GP-1 was reviewed in CQ Magazine in August of
1984 and is great for 4-Square Arrays. The GP-1 is very helpful on
DXpeditions as it makes the installation of Radials very efficient. Used.
$20
6) EZ Hang Kit. Includes the EZ HANG, seven extra weights and clips, a
set of replacement bands, EZ Winder with 500 feet of 150 pound test
intermediate line on a free-spinning stakeable handle. Four cinch points
hold the line for quick and easy unwinding and rewinding. EZ HANG's basic
construction is a welded steel 1/2" rod attached to a reel that is corrosion
resistant plastic and stainless steel. The reel comes with 300 feet of
10-pound-test monofilament line installed, a quick disconnect clip to
release the weight and an easy-to-see "bright yellow" one-ounce lead weight.
This is brand new, never unwrapped. This is everything you'll ever need to
launch a wire antenna or to poke your eye out. $80
73,
Mike, W4UM
South Florida DX Association - http://mailman.qth.net/mailman/listinfo/sfdxa
Florida Contest Group - www.fcg.club
More information about the SFDXA
mailing list