[Rover] DEMI transverter interfacing question

Mon, 15 Jul 2002 21:42:04 -0700

Hi Jacob,

I use the TIB, and love it.  Just set it, and forget it pretty much.

73 & gl,
Dan
Dan Evans N9RLA
Scottsburg, IN 47170
{EM78}
IN-Ham list administrator
QRP-l #1269
1/2 of the N9RLA /R no budget Rover Team
Check out the Rover Resource Page at:
http://www.qsl.net/n9rla

----- Original Message -----
From: "Jacob Tennant" <[email protected]>
To: <[email protected]>; <[email protected]>
Sent: Monday, July 15, 2002 7:39 PM
Subject: [Rover] DEMI transverter interfacing question

> I have a Alinco DX70T and I am wanting to use DEMI transverters for
> 2,222,432 on it.  On the DEMI web site they list 2 interface unit that I
> could use, the AOS-28 and the TIB.
>
> Not having any past experience with either of these units which would you
> folks recommend for a rover setup for the most fool proof system?
>
> MY OBSERVATIONS: The TIB use the ALC system of the radio to control the
> power output of the Alinco so as to prevent frying the TIB & transverter
> versus the AOS-28 where the radio operator must manually turn the radios
> power down to less than 10-watts or else fry the AOS-28.
>
> So what do you think? ? ?
>
> Price difference is minimal 65.00(AOS-28)  vs.  75.00(TIB)
>
> Once again and as always thank you for your replies and patience. As I
said
> in a earlier email all these questions are because after 3 years this
> dream/project is finally going to be getting off of the ground! ! !
>
> Jacob Tennant  K8JWT
>
> _______________________________________________
> Rover mailing list
> [email protected]
> http://mailman.qth.net/mailman/listinfo/rover