[Racal] Panadaptor output from RA6790/GM

Sun, 13 Jan 2002 19:41:30 -0800

Hi,

Can't testify directly to the pan-adapter portion of the question, but may
be able to help with cable/connectors.  You need SMB males, as I recall...I
don't have a receiver at hand at the moment, but-depending on what you do
for a buffer amp, a prefabricated cable might be worth it...even if you need
coax pigtails at your buffer amp, a prefab might help.  Try [email protected] on
ebay...look carefully-he often has SMB male to SMA male cables in the 6 inch
category.  I use them throughout the receivers as adapter-jumpers to test
gear.

hope this helped

regards to all

John Collins
_________________________

----- Original Message -----
From: <[email protected]>
To: <[email protected]>; <[email protected]>
Sent: Sunday, January 13, 2002 07:31 PM
Subject: [Racal] Panadaptor output from RA6790/GM

> Has anyone out there hooked a RA6790/GM to a panoramic scope (
Panadaptor ) ?
> If you have, I would like to know how you did it.
>
> If I have to do this from scratch, I will start by coming off TP3 on board
A3
> and through a buffer amplifier to the outside world.
>
> Also, does anyone have a part number ( preferably Digi-Key or Mouser as I
> gotta order stuff from them this week for another project ) for the
minature
> jacks on the PC cards that connect to the various mini coax cables in the
> radio. I want to unplug the cable presently going from card A4 to IF out
on
> the rear aporn and plug it into the jack that will be on the buffer
amplifier
> card I will make .
>
> Hopefully, I will get time to build this week after next.
>
> Kindest regards,
> Dave
> _______________________________________________
> RACAL mailing list
> [email protected]
> http://mailman.qth.net/mailman/listinfo/racal
>
>