[R-390] Dumb Mechanical Alignment question

[Paul Roche]

OR now that everything is set to 7+000 do I just carefully remove gears, try to to move KHZ or MHZ shaft, and re-assemble with gears in correct positions? That might be easiest. Bandswitch and Geneva gears are at 7+000 right now. 
Sent from my iPhone

> On Jul 14, 2026, at 8:42 PM, PAUL ROCHE via R-390 <r-390 at mailman.qth.net> wrote:
> 
> Now have my detent spring (thanks to Don) and time to get all set for 7.000+. I can pull up all the cams with a tool EXCEPT the second cam from the left, it does not have a clamp. How do I set it up so it is at the line when I am at 7.000+? Do I just leave everthing as it is now (at 7.000), remove gears till I can get at it, and then rotate IT to the line and carefully re-assemble gears and cams? I am afraid if I do this and go back to full CCW it will NOT stay where I want it when I am finally up to 7.000+.
> 
> Am I missing something obvious? I could set all cams to the marks and the counter to 7.000+ and bandswitch correct but then my 10 turn stop on MHZ knob would be off.
> 
> Paul
> ______________________________________________________________
> R-390 mailing list
> Home: http://mailman.qth.net/mailman/listinfo/r-390
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:R-390 at mailman.qth.net
> 
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html