[R-390] PTO end point adjustment

[Barry Scott]

I might be wrong but I think it's a little of both.  Adjusting it
affects both the span between the endpoints as well as the exact
frequency of each endpoint - perhaps one end a bit more than the
other.  Again, I might be wrong about that.

Thanks,
Barry - N4BUQ

On Fri, Nov 8, 2024 at 1:12 PM Jordan Arndt <Outposter30 at shaw.ca> wrote:
>
>
>     It's been a long time since I had to adjust PTO end points and I need
> some advice as to the best method.
>     Do I adjust the coil at the -000 end after setting the +000 end with the
> zero adjust or vice-versa..?
>     Help...73...Jordan VE6ZT
>
> ______________________________________________________________
> R-390 mailing list
> Home: http://mailman.qth.net/mailman/listinfo/r-390
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:R-390 at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html