[R-390] R-390 (non-A) - Low RF Gain or bad Antenna relay?

[Barry Scott]

I just checked resistance from V506 Pin 7 to ground in my R-390/URR
and it checks a few ohms over 820 ohms.

Thanks,
Barry - N4BUQ

On Wed, Nov 6, 2024 at 8:38 PM Barry Scott <72volkswagon at gmail.com> wrote:
>
> That resistance measurement seems quite odd.  R536 is supposed to be
> 820 ohms.  Unless C523 is bad, I don't see how there should be
> anything much less than 820 ohms at pin 7 of V506 yet the resistance
> diagram shows 700 ohms.  99 ohms seems very wrong.
>
> Thanks,
> Barry - N4BUQ
>
> On Wed, Nov 6, 2024 at 8:12 PM <k1jos at att.net> wrote:
> >
> > Update....
> >
> > I checked voltages and resistances per TM  11-5820-357-35 (09 March 1962) for the IF amps V501 - V506.  I don’t know if my R-390 had any mods, its SN 1256, but all the results were very close to the listed values except for V506, 6th IF amp.  The cathode should read  700 ohms to ground and 8.2vdc and I find 99 ohms and 2.3vdc.   The schematic shows the cathode bias resistor of 800 ohms and a 15ohm pot for carrier meter adjustment.  There is a decoupling cap 0.1uF off the cathode that if leaky could bring the resistance down to my reading.   But would this be enough to drop my gain so dramatically?
> >
> > Jerry
> >
> >
> > ______________________________________________________________
> > R-390 mailing list
> > Home: http://mailman.qth.net/mailman/listinfo/r-390
> > Help: http://mailman.qth.net/mmfaq.htm
> > Post: mailto:R-390 at mailman.qth.net
> >
> > This list hosted by: http://www.qsl.net
> > Please help support this email list: http://www.qsl.net/donate.html
> >
> > ______________________________________________________________
> > R-390 mailing list
> > Home: http://mailman.qth.net/mailman/listinfo/r-390
> > Help: http://mailman.qth.net/mmfaq.htm
> > Post: mailto:R-390 at mailman.qth.net
> >
> > This list hosted by: http://www.qsl.net
> > Please help support this email list: http://www.qsl.net/donate.html