[R-390] Looking for Knob Clamp Screw

[Steve Toth]

BarryAs a backup to your backup - I think I have some around also that I bought as spares so if everything else fails, send me an email and i can put a couple in the mail to you.
- Steve  W7SJT

"Always look for a positive solution then Improvise, Adapt, and Overcome"
- Adaptation of the U.S. Marine Corps motto

"There are no rules here!...We're trying to accomplish something!!"

- Thomas Edison


"Success is not final, failure is not fatal.  It is the courage to continue that counts."

- Winston Churchill




On Monday, May 1, 2023 at 10:56:21 AM MDT, Barry <n4buq at knology.net> wrote: 
 
 A list member found one and can send it to me; however, I may have found one within a few miles from my house.  Either way, I think I'm covered.

Thanks!
Barry - N4BUQ

----- Original Message -----
> From: "Barry" <n4buq at knology.net>
> To: "R-390 Mailing List" <r-390 at mailman.qth.net>
> Sent: Monday, May 1, 2023 7:39:22 AM
> Subject: Looking for Knob Clamp Screw

> One of the clamp screws for the KC/MC knobs in my R390 is a hex-drive and the
> other is the standard Bristol spline drive screw.  Anyone know where I might
> find a Bristol screw (5/8" shaft length)?  I realize this is quite a long shot
> and this list is one of the very few places that might know where something
> like this might be had.
> 
> Hex drive isn't a killer but would really like for both of the screws to have
> the original Bristol drive if possible.
> 
> Thanks,
> Barry - N4BUQ
______________________________________________________________
R-390 mailing list
Home: http://mailman.qth.net/mailman/listinfo/r-390
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:R-390 at mailman.qth.net

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html