[R-390] Any advice for removing sheared machine screws...?

[Kevin Schuchmann]

Hi Jordan,
   At least on mine the screws are long enough that they protrude out the backside so if you are taking the panel off you should be able to grab them.
73
Kevin WA7FWF

‐‐‐‐‐‐‐ Original Message ‐‐‐‐‐‐‐

On Sunday, October 3rd, 2021 at 11:05 AM, Jordan Arndt <Outposter30 at shaw.ca> wrote:

> Hi group,
>
> I'm trying to figure out the best way to try and remove 2 of the 4 machine
>
> screws that hold the frequency readout "cover" on a 390A. They were sheared
>
> off at some point and there is not enough metal left to get any kind of grip
>
> with any kind of tool that I have.
>
> I can see that one "stub" has a central divot from a drill bit, and the
>
> other is just a mangled down to where it exits the front panel.
>
> I will likely try to cut a slot in what's left of the metal with my Dremel
>
> tool, and see if I can get enough grip with a small screwdriver to unscrew
>
> the remnants, but I have my doubts because I expect they were badly
>
> overtorqued and likely held tight in the threads...
>
> I have to pull the front panel anyway, so I'll get a look at things from the
>
> rear of the front panel when I do that...
>
> Any tips or pointers out there...??
>
> 73...Jordan VE6ZT
>
> R-390 mailing list
>
> Home: http://mailman.qth.net/mailman/listinfo/r-390
>
> Help: http://mailman.qth.net/mmfaq.htm
>
> Post: mailto:R-390 at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
>
> Please help support this email list: http://www.qsl.net/donate.html