[R-390] screws and washers

[Ron.K3PID]

I am quite fortunate in that I have an excellent ACE hardware in the near by 
town and he has about any fastener you can think of and if he doesn't he 
will get it for you. AND if that fails ( only once when I needed a shoulder 
bolt with a non-standard shaft length) I also have a Fastenal store not too 
far away. If they don't have it, it probably doesn't exist however they 
usually want to sell you a box of them...

Ron K3PID

-----Original Message----- 
From: Joe Koester
Sent: Wednesday, May 22, 2019 8:46 PM
To: R-390 at mailman.qth.net
Subject: [R-390] screws and washers

Hey guys,



I am looking to get my R390A and my R725 into cabinets.  Back in the day
these things were help in place with I think a 10-32 screw with an oval head
and a finishing washer.  Also as far as I remember the recorders and other
stuff was rack mounted the same way. I am trying to locate the right screws,
which I think were ?? or 1 inch and may have been ???pan head, as well as the
washers.



I want this to look nice and original.  Anyone know where I can get what I
am looking for, even used would be great if anyone has a stash ??? I need 16.



Thanks,



Joe



Joseph W. Koester, W4NSA

1020 Huron Drive

Crossville, TN 38572-6304

931-788-1360 (home)

931-200-0243 (cell)

jwkoest at charter.net <mailto:jwkoest at charter.net>



______________________________________________________________
R-390 mailing list
Home: http://mailman.qth.net/mailman/listinfo/r-390
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:R-390 at mailman.qth.net

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html