[R-390] Cutting aluminum sheet

[Bill Guyger]

I'm talking about a hand held Bosch saber saw. The blade is only about 4" over all length and the cutting area is 3" +/-. And having looked it is 17 teeth/ vs. 14

Sent from my iPhone

> On Oct 28, 2016, at 1:30 PM, Charles Steinmetz <csteinmetz at yandex.com> wrote:
> 
> Bill wrote:
> 
>> As I mentioned earlier I use a saber saw but I do use a fairly course blade IIRC 14 teeth/inch.
> 
> That is extremely fine compared to the OP's blade.  Your blade has over 300 teeth (assuming it is a standard 7-1/4" blade), while his has only 40 (about 1.25 teeth/inch).
> 
> Best regards,
> 
> Charles
> 
> 
> ______________________________________________________________
> R-390 mailing list
> Home: http://mailman.qth.net/mailman/listinfo/r-390
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:R-390 at mailman.qth.net
> 
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html