[R-390] R-390 IF adjustment of .1 1. bandwidth

[Roger Ruszkowski]

Dave,

I see what you say.

We should center the signal generator for a peak through the crystal
as was done originally. Then you align the rest of the IF deck to what
ever that frequency is some where near 455 and well within the mechanical
filter band passes. We then work on getting L503 and the trim cap
to get the best 1Khz we can.

You zero the BFO to the what ever the peak frequency through the .1 kHz 
crystal happens to be. 

What ever the If center is we care not. You just also adjust the VFO 
to zero through the crystal against the BFO. 

So what if the IF deck is not an exact 455. 
Those receivers have worked for at least 60 years that way.

If you have to use a counter, then 1 KHz bandwidth may not be zackly 1.

But I will bet you can't hear the difference.

I think I am diddling in the mud on this point.

How do we best adjust the slug and the cap for a good 1Khz bandwidth?

Roger 



-----Original Message-----
From: David Wise <David_Wise at Phoenix.com>
To: R-390 <R-390 at mailman.qth.net>
Sent: Mon, Oct 21, 2013 6:16 pm
Subject: Re: [R-390] R-390 IF adjustment of .1 1. bandwidth


There isn't any trim to bend the crystal, you just have to take what you get.

L503 is adjusted to resonate at the crystal frequency in order to get the widest 
1kHz bandwidth.  (R502 and R503 "spoil" L503/C524 by a calibrated amount to get 
1kHz or 100Hz respectively.)

I think C520 is adjusted to balance out stray capacitance at the crystal's 
parallel-resonant frequency.

Dave Wise

-----Original Message-----
From: r-390-bounces at mailman.qth.net [mailto:r-390-bounces at mailman.qth.net] On 
Behalf Of Roger Ruszkowski
Sent: Monday, October 21, 2013 1:38 PM
To: R-390 at mailman.qth.net
Subject: [R-390] R-390 IF adjustment of .1 1. bandwith


Bill,

Now that we have counters the question becomes how to 
adjust the trim cap to pull the crystal onto 455 and get the 1Khz
band pass also centered on the 455.

As the TM came before counters, the TM does not 
address this adjustment process.

Fellows how should we conduct this adjustment process?

Roger.

______________________________________________________________
R-390 mailing list
Home: http://mailman.qth.net/mailman/listinfo/r-390
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:R-390 at mailman.qth.net

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html