[R-390] Bristol Wrench

[Roger Ruszkowski]

Dave,

If your receiver is original it only had 1 size Bristol knob screws, slug screws and
clamp screws. Or bolts.

Other things got installed over the years that are not standard.

I once found some long handle drivers that were meant to hold
Allen key stock  I used a grinder to cut a Bristol L key off to get a length of
straight stock and mounted it into the driver. My driver was about 8: long.
But the grip was not overly large in diameter.
It makes a nice Bristol wrench for the receivers.

Roger.


-----Original Message-----
From: quartz55 <quartz55 at hughes.net>
To: R-390 <R-390 at mailman.qth.net>
Sent: Thu, Nov 28, 2013 3:37 pm
Subject: [R-390] Bristol Wrench


What is the standard size L wrench for the knobs.  S-096-6?  Which would make 
the bit size B-096-6.  0.096" max dia.?  I'd like to get a few of them.  Are 
there any other Bristow sized screw heads in the R390-A?  I do have a complete L 
set, but would rather have a screwdriver type.

Dave
N3DT
______________________________________________________________
R-390 mailing list
Home: http://mailman.qth.net/mailman/listinfo/r-390
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:R-390 at mailman.qth.net

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html