[R-390] Panel Screws for harness

[Roger Ruszkowski]

Dave,

The wire harness screws had a flat washer and a locking nut.

The locking was a plastic insert in the top of the nut.

Much like the locking device in the captive nuts where
the front panel goes to the frame.

The flat washer was a "fender washer" small hole for
6x32 and larger diameter to cover the hole in the
wire harness clamp.

Things got dropped on the floor and sweep up in the trash.

You just used what ever you could find in the ME9 kit.

As mail cost is going to exceed parts cost, you could include
a couple five of the 6x32 locking nuts and flat washers.

I could see you doing a whole $10.00 Kit

10 x32 
6x32
star washers.
some 6x32 straight heads for the terminal boards
10x32 green screw sizes.
some 4x40 spline or Allen head for the clamps.
4x40 nuts for the clamp screws
some spline screws for the knobs.
some little screws for the bezel.
some little screws for the meters.
add in a micro scope slide for the dial glass
four little screws for the ID plate.

Put all the parts in a padded mailer

Post the package  on your web site.
You will become the go to place for every one who needs some thing
in the kit.

$10.00 solves it all.

You will never get rich but R390 owners around the world will love you.

Roger AI4NI