[R-390] VFO End points

[Barry]

If I'm not mistaken, the single endpoint adjustment affects the overall range the PTO covers in 10 turns.  Yours is not quite changing a full 1,000kc.  If you change the endpoint setting, it should affect both ends.

I think you're within specs but you can probably get it closer if you want.

Someone please chime in here if I'm incorrect.

Regards,
Barry - N4BUQ

----- Original Message -----
> From: "Gordon" <gordon at n6wk.com>
> To: R-390 at mailman.qth.net
> Sent: Friday, May 24, 2013 11:28:37 AM
> Subject: [R-390] VFO End points
> 
> I noticed today that my 390A zero beats at +003  and at -997
> so it is 3 high on one end and 3 low one the other. It is pretty
> close
> to dead on at the 500 Mark.
> Will the single End point adjustment at +000 fix this or make the low
> end worse?
> 
> Thanks,
> Gordon
> 
> 
> 
> ______________________________________________________________
> R-390 mailing list
> Home: http://mailman.qth.net/mailman/listinfo/r-390
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:R-390 at mailman.qth.net
> 
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
>