[R-390] R-390A Zero adjust

[Bob Young]

Good, then it won't be a waste of time to take the assembly out, the three holes seems to line up right but again it's difficult to see in there but something is stopping the clutch from moving out freely. 

Bob KB1OKL

> Date: Sat, 16 Mar 2013 17:06:31 -0500
> From: n4buq at knology.net
> To: r-390 at mailman.qth.net
> Subject: Re: [R-390] R-390A Zero adjust
> 
> No, it is not.  There are several (6?) discs that are compressed by a 
> few (3?) compression washers.  If anything isn't working freely, it can 
> cause these symptoms.  There are several little holes that have to 
> align, etc.  It can all be taken apart, cleaned, examined for proper 
> movements/sliding, and reassembled.  Reassembly is a bit difficult, 
> though, as I recall, as you have to compress the spring washers and get 
> a grip ring in place and into a groove (I think).  It has been a long 
> time since I did this...
> 
> Barry - N4BUQ
> 
> On 3/16/2013 4:30 PM, Bob Young wrote:
> > Does anyone know if this clutch assembly is all one piece? it appears that way.
> >
> > Bob
> > KB1OKL