[R-390] Broken part need help

[Charles P. Steinmetz]

Norman wrote:

>When disconnecting a lead during a component replacement, it's best 
>to snip said lead carefully and to use judicious heat when 
>desoldering the wire bit around the terminal.

When I need to unsolder something from one of these terminal posts, I 
unscrew the post from the chassis first.  That way, I'm not putting 
any strain on the post itself -- any pulling and prying is against 
the other wires/components connected to the terminal end.

A good vacuum desoldering iron lets you minimize the amount of heat 
you need to use to get things free.

Best regards,

Charles