[R-390] MFP Problem

[Flowertime01 at wmconnect.com]

Perry,

Back when we just applied far to much heat with an over size 40 watt iron.
That would sort of melt down / burn the MFP.
Do not sniff that smoke
And brushed off the solder and burnt MFP with the wire solder brush.
A big tip solder sucker would pick most of it out.
A knife would chip some more off.
By the time you had the old wire lead out of the joint you had cleaned off 
enough of the terminal to get a solder joint back on the terminal.

Try not to fry the wire harness wire.

We had small 2 OZ bottles of the MFP stuff like finger nail polish bottles 
to reapply. 
Heaven or Connie only knows what the NSN was for the little bottles.
Opt for zero replacement unless needed in your QTH.

Roger AI4NI
</HTML>