[R-390] RF Module Adjustable Slug Seperated from Adjusting Screw

[Paul Dulaff]

I have an R390 which I got working over the weekend. On the 16-32 Mhz slug rack, the front most slug has mechanically seperated from the adjuster screw. I took the slug and adjuster screw out of the set. It appears that the small spring shaft between the slug and the adjuster screw was soldered to the inside of the adjuster screw. Do I just push the small spring shaft into the bored hole in the adjuster screw as far as it will go and solder then back together ? Is there a dimension I need to control to as far as placement of the small shaft spring in the adjuster screw ?

Regards

Paul - WB2NMI