[R-390] OT: HP-410B Tubes

[Steve Byan]

On Mar 4, 2011, at 10:47 PM, Barry wrote:

> It wasn't too hard to do.  If you remove the switches, pots, and panel lamp from the front panel, it all comes apart pretty readily.  In order to replace the bypass caps on V2, I had to remove the screws that hold the resistor board and move it out of the way as much as possible.  After that. it's not too bad.

Thanks, now that you point it out it's obvious :-)

Best regards,
-Steve

-- 
Steve Byan <stevebyan at me.com>
Littleton, MA 01460