[R-390] Rf Deck MC Change Gear

[Flowertime01 at wmconnect.com]

Dennis,

Nothing magic here. Put it in back wards if you need to.

In my receiver the clamp sets against the front bushing.

Loosen the split gear clamp on the Mhz shaft
Slide the split gear back off the brass gear (only one split needs to slide 
off)
Load the split gear on tooth of spring tension (no need to over load)
Slide the split gears to about center on the brass gear so they do not on 
load when the back split gear runs off the brass gear.
Leave just a little oil space between the clamp and the plate.

You gear pair may not be tightly together thus the clamp sets a bit forward 
and rubs.

You should be able to get the split gear to run on the brass gear and not 
have the clamp run against the front plate.

If not then turn it around and run it that way

Roger AI4NI</HTML>