[R-390] PTO

[Craig C Heaton]

Looking back, I think this is still about an "A". So if it is get a copy of
the Y2K, print the beast and follow along.

The mechanical alignment has to be done first, check cam position at 7 +000,
etc. If the receiver can hear signals, set it for one of WWV's TX's; 5 10 15
or 20 MHz. Loosen a clamp on the PTO, keep the veeder root, cams, etc from
moving, turn PTO shaft only until WWV is zero beat. (BFO on)

This should get you in the ball park. 

Craig,

-----Original Message-----
From: r-390-bounces at mailman.qth.net [mailto:r-390-bounces at mailman.qth.net]
On Behalf Of ka9egw at britewerkz.com
Sent: Friday, September 03, 2010 5:37 PM
To: r-390 at mailman.qth.net
Subject: [R-390] PTO

The saga continues...it goes without saying the rf deck is now horribly out
of alignment.  I can get the rx to hear my sig/gen on the antenna input, but
that's about it.

Lacking access to a freq counter, but having a decent sandstate general
coverage rx, [a Rat Shack DX390 which is possibly too sensitive for this
use] how do I go about telling where the pto is really at?  I've got more
than my share of intermod and spurious mixing products and can blank the
receiver 50 times when tuned through 10 turns starting at the
counterclocksise.  [When I say 'stop' I mean that point where the resistance
of the bare pto shaft to my bare fingers just starts to increase marginally,
I am being very careful not to run the pto past it's physical limits...]

Assuming I'm at the full CCW stop on the pto, where should it be?  It's a
Collins PTO FWIW.

I won't even go into my planned 'someday' change to the Cosmos I have on teh
shelf...

Any help would be appreciated.

73 de KA9EGW

______________________________________________________________
R-390 mailing list
Home: http://mailman.qth.net/mailman/listinfo/r-390
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:R-390 at mailman.qth.net

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html