[R-390] Screws & Washers for r-390/urr

[Flowertime01 at wmconnect.com]

Harold,

 If your CY-979/URR cabinet has bolt holes with threads in the holes you 
need a 10 x32 bolt any length over a 1/2 inch will work. 3/4 and 1 inch were 
popular lengths. You could get the bolt started and then as you run one in 
you could boost the receiver up into alignment. You could put a long one in 
the bottom edge and us it to crank the receiver up level front to back into 
the cabinet.

If the cabinet has tinner nuts (flat sheet metal clips) use a 10 x 24 bolt. 

There are also clip on nuts in both 10 x32 and 10 x 24 flavors. Stop by 
your local hardware store and buy a couple of each blot thread to see what fits.

Pull a 10 x 32 (big one) out of the front panel of the receiver and see it 
fits thread wise into the cabinet bolt holes.

Any style head will do. Flat slots were mostly used in the front of the 
racks.  Philips were also popular. No washer was used but there are some nice 
decorative washers that you may want to consider. It would be a mater of you 
choice of style.

My Yankee screw driver still has a flat bit I used to get receivers in and 
out. We did all 8 screws out and back in every receiver every time.

Roger AI4NI</HTML>