[R-390] Bandswitch 7.000+ picture/position

[Paul Anderson]

On Wed, Jun 24, 2009 at 5:33 PM, <Flowertime01 at wmconnect.com> wrote:
> Steve,
>
> The goal is to get maximum metal to metal switch contact in each wafer and
> in each position.
>
> It is a best judgment call of all the wafers in all the positions.
...
> The real solution is best eye and lots of checking several times both up
> and down. Just a little bit of change in the shaft and clamp can make or break
> an alignment.

One additional thing I found was that not having the right shims in
the geneva coupler to hold it nice and square means the additional
slop translates to more lash in this critical area.  So make sure that
when you are operating the MC knob that the coupler is not tilting
slightly due to various forces on it.

Paul