[R-390] Microswitch

[Cecil Acuff]

Dan you need to learn Redneck.  It comes in handy.  I know there were lots 
of them in SoCal...it's not just a southeastern US thing.

Probably could have had those guys eating out of your hand with a six pack 
and some Kielbasa....

Cecil
----- Original Message ----- 
From: "Dan Arney" <hankarn at pacbell.net>
To: "R-390 List" <r-390 at mailman.qth.net>
Sent: Friday, February 27, 2009 2:55 PM
Subject: Re: [R-390] Microswitch


> Hi Gang,
>
> After a 2 1/2 year battle with the redneck  mayor and his cloned
> rednecks and over 10,000.00 in attorneys, PE, Plat Survey, variance fee,
> Permit fee. I finally got the permit with a bunch of restrictions.
> For me to proceed in Federal Court it would cost me at least 20 to 35 K
> of funds which I do not have.
>
> OOPS the micro switch I need is for the rotation limit switch for the
> prop pitch motor on the Skyneedle. It is a NC 2 terminal with a lever
> about 2 inches long and 1/4 wide. which got broken at the end of the 
> switch.
>  The switch is fine.
> Sylvia at Mouser no stock and with Microswitch they say no  such number.
> The switch. says Microswitch Type Z and on the side it says WZ RL11.
> So if anyone has the switch or lever in your junque box or know where I
> can purchase 1 or 2 for spares. please let me know ASAP  the base is
> poured and has cured for 10 days on 3/3/09.
> TIA,
> Hank
> KN6DI/5
> ______________________________________________________________
> R-390 mailing list
> Home: http://mailman.qth.net/mailman/listinfo/r-390
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:R-390 at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
>