[R-390] Paint Removal

[Dave Faria]

The way I like to remove paint from the panel lettering, after the surface
is as clean, is I have one of the cheap 110vac power washers.  I set the
wand to a pencil point stream and the paint comes right out of the
engraving.  I lay the panel on a couple pieces of card board and once the
card board gets wet the panel will not move.  I also use aircraft paint
stripper from Home Depot to remove the surface paint.  This saves me time
cause I can never get a panel right the 1st time or sometimes the 2nd or
3rd.................